RockBoard RPA 100 Power Attenuator

The Rockboard RPA100 Power Attenuator allows you to set your amp to your preferred sound - including high-gain and power amp distortion - and then lower the volume on the speaker to an acceptable level for onstage or in the practice room without affecting the sound of the amp. This is especially useful if you play on a tube amp.

The Rockboard RPA 100 Power Attenuator can be used to "tame" amplifiers rated up to 100 watts. With a choice of 4, 8 and 16 ohm connections, your amp will always see the correct speaker impedance regardless of the type of speakers actually connected to the attenuator. You can even use the amplifier without speakers and listen to the signal through headphones. In addition, the RPA 100 Power Attenuator gives you the ability to route your power amplifier's output to mixers or audio interface applications via DI OUT or LINE OUT, or to practice with the amplifier's original sound through the headphone output.

For a more realistic sound, cab simulations can be applied to these additional outputs. For practice, you can mix backing tracks or drum tracks from external audio devices via the AUX IN jack.